The types of engraving methods very virtually metals are as follows.
-Percussion engraving (percussion or needle engraving)
-Scribe engraving (scratching)
-Roll marking engraving
-Laser engraving
-Gate engraving and chip removal
-facilitate engraving (Percy)
-Electrochemical etching
Percussion engraving robot (percussion, needle)
The pen mechanism of devices in the percussion engraving method is in two ways.
-Pneumatic engraving robot
-Magnetic engraving robot
Impact engraving or percussion in a pneumatic quirk
In the pneumatic method, the driving force of the pen is provided by wind, which is straightforward in swap models for engraving swap parts
Magnetic needle engraving or hammering
In the magnetic method, the faculty of the device is supplied by the coils of the pen and is controlled by electronic circuits, after that again in the pneumatic method. The number of points in the magnet pen can be controlled and adjusted. The magnetic system has less intensity and far away afield less noise pollution than the pneumatic system.
Laser engraving
In the laser method, the ray is produced by stimulating the laser generating material by electric release or the radiation of a lamp in a chamber, and the beam is reflected using a mirror to get your hands on the necessary liveliness to become a fresh stream. The mirror is usually used to guide the light to the lens, and through the lens, the spacious shines upon the slant, and engraving is finished.
Scribe or graze engraving
It is one of the newest engraving methods in the world. In this method, the needle of the machine, which is usually made of tungsten carbide, penetrates the surface of the desired piece or sheet and subsequently performs the engraving operation. A every one of adherent way to engrave once very high mood and without any noise pollution (shy) is the best fresh marginal in cases where there are restrictions related to noise pollution. دستگاه حکاکی روی فلز
Comments
Post a Comment